You can route MIDI over your Ethernet network, using ipMIDI ports to send and receive MIDI data between computers connected to your LAN. For example, if you have a music studio with several computers connected via MIDI interfaces and MIDI cables, ipMIDI will replace them all.
Any MIDI application on the LAN can communicate with any other without any new physical connections, eliminating separate MIDI cables and additional hardware interfaces and if you are running a wireless IP network you don’t need any cables at all! This is becoming more in demand, the ability to just establish a temporary local wireless network and hook in the PCs.
ipMIDI sends MIDI data over Multicast UDP, not TCP. It’s very easy to use.
Select "1. Ethernet Midi" in your audio Application”. That's all, no configuration, no client - server hassle. You will not have to define a sender or a receiver, a master or a slave. Choose a ethernet MIDI OUT port for your sending application. Now every single application on your network can receive the data by opening an ethernet MIDI IN port, simultaneously.
MIDI data is only transferred in your subnet – that is, between all computers connected with hubs and switches. It won’t go across a router, so you do not have to fear your data will be visible in the Internet.
ipMIDI is a native Windows™ WDM kernel mode driver. In your local network you can expect a latency < 0.5 msec, lower than when using legacy hardware equipment and real MIDI cables.
A standard MIDI interface sends with a data rate of 31.2 kbaud, which has limitations. For example, sending excessive Polyphonic-Aftertouch MIDI messages easily breaks this limit. With ipMIDI this limit is defined by your network data rate. Think of the amazing possibilities to work with your network rate of 1Gbit/s.
In the ipMIDI network, all MIDI is transmitted over a single port could be received by every computer, ipMIDI replaces more than 20 MIDI cables, establishing an “n-way MIDI network”.
You may connect up to 8 applications to every inport and up to 8 application to every outport on every single pc in your MIDI network. Every port provides the full 16 MIDI channels.
The numbers of ports are adjustable. Select only the number you need and only those will be installed on your system and be visible in your audio applications. This will save system resources and usability.
ipMIDI comes with a system tray application (ipMIDI Monitor) to mute every MIDI port individually. A muted port behaves similar like an audio port. All data sent to the port is simply discarded, but the sending application will not realize anything. Muting a port closes all network connections used by this port.
With the "Loop back" checkbox you can define how your MIDI messages are routed.
If you disable loop back, only application hosted on another computer will receive MIDI. This is the prefered way when you start a simple setup.
With loop back enabled, applications hosted within the same computer and your sending application, will additional receive your MIDI data.
Double-click the ipMIDI installer and you are ready to use ipMIDI. Thats all.
Starting the uninstaller will completely remove ipMIDI from your system again.
This software is not reviewed yet.
LoopBe30 is a virtual MIDI device driver for transferring MIDI data between computer programs. Basically LoopBe30 provides up to 30 independent invisible cables to connect MIDI outports of applications to any other application's MIDI inport.
LoopBeAudio is a virtual audio device to transfer audio between computer programs, digitally, without any quality loss. Build a virtual 7.1 surround device, even though you don't have the built-in hardware. Configure up to 24 audio channels.